Videx 8K-1 Manuel D'installation page 4

Audiokit 8K Series
8000 Series
Surface and flush mounting door station installation
INSTALLING A FLUSH MOUNTING DOOR STATION
1. Mount back box (Fig. 2) at 165 cm from ground level (Fig. 1);
S
2. If more than one flush box is needed, connect them by using the plastic spacers provided
3. If necessary finish and clean properly the module support fixing holes and all other holes
(Fig. 3 & 4) can be mounted using the fixing screws
4. A rainshield
D
protect against rain;
In order to prevent water ingress we highly recommend using a silicon sealant between the wall and the back box
and between the wall and the rainshield
5. Remove the fixing screws
6. Insert the modules
F
7. Insert the microphone of the door unit amplifier into the microphone hole
8. Secure the modules by refitting the plastic cover
(Fig. 9) and fix it with the two screws
9. Insert the hinge
I
10. Make all connections following accurately the wiring diagram provided. Check the installation and if necessary adjust speech
levels using volume controls
(Fig. 10) upwards and fix it to the back box with the screw
11. Lever the support
R
12. Conceal the screw using the plastic cover
INSTALLING A SURFACE MOUNTING DOOR STATION
Fix the surface box on the wall at a distance of 165 cm between the top of the box and the ground (Fig. 1).
In order to prevent water ingress we highly recommend using a silicon sealant between the wall and the back box
(Fig.12) and around all holes
To complete the installation follow the same steps described above for the flush box.
Note: if additional holes are made in the box or rainshield, oxidation problems may appear unless the
unprotected metal is coated with a protective paint.
HOW TO REMOVE THE CARD NAME HOLDER
• To avoid damage to the module front plate, tape the side that will be in contact with the screwdriver blade;
• lnsert a flat screwdriver into the card-holder hole as shown in Fig. 13;
• Move the screwdriver to the left as shown in Fig. 14 to extract the card name holder;
• Edit the card name then replace it inside the holder and refit: insert the holder inside its housing from the left or right side then
push the other side until it clips into place.
Art. 8K-1, 8K-2, 8K-N users - Installation instructions
D
(Fig. 5) and remove the plastic cover
H
(Fig. 6) according the required configuration;
(Fig. 9);
L
(Fig. 11) provided.
N
(Fig.12).
W
(Fig. 4) to conceal possible wall finishing defects and
G
(Fig.3);
(Fig. 5) of the module support;
E
(Fig. 8) and using the screws
E
(Fig. 9) provided;
K
- 4 -
(Fig. 2);
A
(Fig. 2);
B
(Fig. 7);
X
(Fig. 8);
H
(Fig. 11) using an alan key
M
(Fig. 11);
P
J
66250840 - V5.2 - 31/03/22