Videx 6200 Serie Mode D'emploi
  1. Manuels
  2. Marques
  3. Videx Manuels
  4. Systèmes d'interphone
  5. 6200 Série
  6. Mode d'emploi

Videx 6200 Serie Mode D'emploi

Masquer les pouces Voir aussi pour 6200 Serie:

Publicité

Les langues disponibles

Les langues disponibles

Table des Matières

6200 Series
Art. 6256
3.5" colour videophone
27 mm
Fig. 1
DESCRIPTION
Surface mount videophone incorporating a 3.5" Hi-Res full
colour active matrix LCD monitor specific for "6 wire" videokit
(VK4K, VRVK and VK8K range). It includes 4 buttons: "camera re-
call", "open door" , "service" and "privacy".
2 LED's* indicate the privacy activated and open door. Program-
mable privacy duration and number of rings. Intercommunicat-
ing call and door call. Adjustments: call tone volume switch (3
levels), picture hue, contrast and brightness.
* The operation of some LED's and the functions described may require additional cabling
PUSH BUTTONS
Service push button
Shorts the "SB" terminal to GROUND (open collector 24Vdc 100mA max) while the button remain pressed.
Camera recall button
Pick up the handset then press the button (Press once for door/gate 1, twice for 2 and so on up to a maximum of 4 entranc-
es): the relevant LED switches ON and the monitor switches on showing the video from the door panel. The speech is also
live and the door can be opened by pressing
Door-open / intercommunicating call button
With the handset lifted and speech lines open to the entrance panel, press this button to open the door. If the terminal "LD"
is properly connected the relevant LED remains switched ON until the door is closed.
Intercommunication only works when the system is in stand-by condition.
Switch 4 of the SW1 dip-switch selects the type of intercommunication:
OFF Intercommunication between two apartments - pick up the handset and press the key button to call the videophone(s)
in the other apartment. A busy tone will signal that the other videophone is in conversation with the door station and
so cannot be called.
ON Intercommunication between videophones in the same apartment
- pick up the handset and press the key button one, two, three or four times to call videophone with extension address 1, 2,
3 or 4 (Set on dip-switch 2&3 of SW1).
Any intercommunicating conversation is always interrupted by an external call (i.e. External calls take priority).
Privacy ON-OFF button
When the system is in stand-by, the pressing of this button activates (LED switched on) or disables (LED switched off ) the
"privacy" service. The service is automatically disabled when the programmed privacy time expires. When the service is
enabled the videophone does not receive calls.
Art. 6256 - Installation instructions
144 mm
.
D
Fig. 2
LEGEND
Connection terminals
A
8 Way dip switch bank
B
2 Way dip switch bank
C
Contrast adjustment trimmer
D
Hue adjustment trimmer
E
Brightness control
F
Call tone volume switch
G
- 1 -
A
B
C
PT3 PT2
E
PT1
SW1
F
G
66251130 - V2.0 - 31/05/18

Publicité

Table des Matières
loading

Manuels Connexes pour Videx 6200 Serie

Sommaire des Matières pour Videx 6200 Serie

  • Page 1 6200 Series Art. 6256 3.5" colour videophone 27 mm 144 mm PT3 PT2 Fig. 1 Fig. 2 DESCRIPTION LEGEND Surface mount videophone incorporating a 3.5” Hi-Res full Connection terminals colour active matrix LCD monitor specific for “6 wire” videokit 8 Way dip switch bank (VK4K, VRVK and VK8K range).

  • Page 2: Technical Specification

    6200 Series Art. 6256 3.5" colour videophone LEDS CONTROLS Call tone volume switch Door open LED (3 levels). Can be used to indicate the status of a door or gate. It re- Brightness control quires a switched 12Vdc connection to terminal “LD”. (sliding wheel).
  • Page 3 6200 Series 6200 Series Videophone wall mounting instructions Fig. 1 Fig. 2 Fig. 3 Fig. 5 Fig. 4 Fig. 6 Fig. 7 1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base: firstly disconnect the handset from the videophone (by removing its plug from the videophone) then insert a 5.5mm flat screw driv- er into the clip then rotate clockwise until you listen a “CLICK!”.
  • Page 4 Serie 6200 Art. 6256 videocitofono 3,5" a colori 27 mm 144 mm PT3 PT2 Fig. 1 Fig. 2 DESCRIZIONE LEGENDA Videocitofono montaggio da superficie con monitor a colori alta Morsettiera di connessione risoluzione LCD TFT da 3,5” specifico per Videokit “6 fili” (gamme Dip-switch ad 8 vie VK4K, VRVK e VK8K).

  • Page 5: Controlli E Regolazioni

    Serie 6200 Art. 6256 videocitofono 3,5" a colori CONTROLLI E REGOLAZIONI Door open LED Regolazione volume della nota elettronica Può essere utilizzato per qualsiasi genere di segna- (3 livelli). lazione (di norma lo stato di apertura/chiusura della Regolazione luminosità porta). Richiede una connessione adeguata al tipo di (rotella di regolazione).
  • Page 6 Serie 6200 Serie 6200 Istruzioni di installazione a parete Fig. 1 Fig. 2 Fig. 3 Fig. 5 Fig. 4 Fig. 6 Fig. 7 1. Per installare il videocitofono è necessario aprirlo separando la base dal coperchio che ospita tutta l’elettronica dello stesso: scollegare la cornetta dal videocitofono rimuovendo il relativo plug quindi inserire la punta di un giravite piatto da 5.5mm nella clip dopodiché...
  • Page 7 Série 6200 Art. 6256 interphone vidéo 3,5" en couleurs 27 mm 144 mm PT3 PT2 Fig. 1 Fig. 2 DESCRIPTION LÉGENDE Interphone vidéo montage de surface avec écran en couleurs Bornes de branchement haute résolution LCD TFT de 3,5” spécifique pour Kit vidéo « 6 Dip-switch à...

  • Page 8: Contrôles Et Réglages

    Série 6200 Art. 6256 interphone vidéo 3,5" en couleurs CONTRÔLES ET RÉGLAGES Door open LED Réglage volume de la note électronique Elle peut être utilisée pour tout type de signalisation (3 niveaux). (en général l'état d'ouverture/fermeture de la porte). PT1 Réglage luminosité Elle nécessite d'une connexion adéquate au type de signalisation.
  • Page 9 Série 6200 Série 6200 Instructions d'installation murale Fig. 1 Fig. 2 Fig. 3 Fig. 5 Fig. 4 Fig. 6 Fig. 7 1. Pour installer l’interphone vidéo il faut l’ouvrir en séparant la base du couvercle qui contient toute son électronique : débranch- er le combiné...
  • Page 10 Door Monitor Title: Data creazione: Foglio 23/10/2015 Titolo: Data modifica: 18/11/2015 Videx Electronics S.p.A. Notes: Autore: Marco Rongoni Via del Lavoro 1, 63020 Monte Giberto (AP) Note: Cod.File: Phone: +39 0734 631669 - Fax +39 0734 631669 vk4k62h-002.dwg www.videx.it - info@videx.it - 10 - 66251130 - V2.0 - 31/05/18...
  • Page 11 Art.8833-1 Art.8833-1 Title: Data creazione: Foglio 17/11/2015 Titolo: Data modifica: 17/11/2015 Videx Electronics S.p.A. Notes: Autore: Marco Rongoni Via del Lavoro 1, 63020 Monte Giberto (AP) Note: Cod.File: Phone: +39 0734 631669 - Fax +39 0734 631669 vk8k62h-002.dwg www.videx.it - info@videx.it - 11 - 66251130 - V2.0 - 31/05/18...
  • Page 12 Art.140 Art.140 Title: Data creazione: Foglio 22/10/2015 Titolo: Data modifica: 01/12/2015 Videx Electronics S.p.A. Notes: Autore: Marco Rongoni Via del Lavoro 1, 63846 Monte Giberto (FM) Note: Cod.File: Phone: +39 0734 631669 - Fax +39 0734 631669 vrvk62h-001.dwg www.videx.it - info@videx.it - 12 - 66251130 - V2.0 - 31/05/18...
  • Page 13 Title: Data creazione: Foglio 17/11/2015 Titolo: Data modifica: 18/11/2015 Videx Electronics S.p.A. Notes: Autore: Marco Rongoni Via del Lavoro 1, 63020 Monte Giberto (AP) Note: Cod.File: Phone: +39 0734 631669 - Fax +39 0734 631669 vk4k62h-012.dwg www.videx.it - info@videx.it - 13 -...
  • Page 14 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 01/12/2015 01/12/2015 Marco Rongoni vk8k62h-008.dwg - 14 - 66251130 - V2.0 - 31/05/18...
  • Page 15 - 15 - 66251130 - V2.0 - 31/05/18...
  • Page 16 MANUFACTURER VIDEX ELECTRONICS S.P.A. FABBRICANTE Via del Lavoro, 1 FABRICANT 63846 Monte Giberto (FM) Italy FABRICANTE Tel (+39) 0734 631669 FABRIKANT Fax (+39) 0734 632475 www.videx.it - info@videx.it CUSTOMER SUPPORT VIDEX ELECTRONICS S.P.A. UK Customers only: SUPPORTO CLIENTI VIDEX SECURITY LTD www.videx.it - technical@videx.it...

Ce manuel est également adapté pour:

6256

Table des Matières