Cequent Performance Products 51239 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Rear
Impact
structure
chain loops
Figure 1
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
1. Remove (4) bolts from the bottom of the impact structure. See Figure 1. Return bolts to owner.
2. Raise hitch into position and install provided fasteners as shown. See Figure 2.
3. Tighten all M14 CL10.9 fasteners with torque wrench to 100 Lb.-Ft. (136 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
© 2014, 2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 51239, 97239
Fastener Kit: 51239F
Bumper
channel
Bumper
Impact
structure
Due to vehicle
variance if may be
necessary to bend
impact structure
chain loop for
additional clearance
Figure 2
Remove plastic wire retainer on the outside
of the drivers side bumper channel, if it
interferes with the hitch installation.
Sheet 3 of 12
① Qty. (4) Bolt
M14 X 2.00 X 45mm CL10.9
② Qty. (4)
Lockwasher 9/16"
③ Qty. (4) Spacer
.250 x 1 x2
③
②
①
51239NP 03-26-15
j
Rev. D