Slot Cuts; Operation Notices; Maintenance; Maintenance Schedule - HOLZMANN MASCHINEN KAP 255XJL Mode D'emploi

 Disadvantage: You MUST fix workpiece additionaly with downholder (19) to prevent it from
kickback.

13.3.3 Slot cuts

 Clap the depth stop (27) to the side so that the adjustment screw touches the depth stop
(27) when swinging down the saw arm.
 Adjust the adjustment screw for slut cuts as desired.
13.4

OPERATION NOTICES

 Always use well sharpened saw blades. Deflected, cracked or worn saw blades are a security
risk and have to be replaced immediately!
 Assure yourself that you do not overload the machine. Use it for operations it is designed
for.
 Choose always saw blades where at least 2-3 teeth are simultaneously in the material to
achieve a clean cut and to reduce the risk of material kickback.
 For precision miter and bevele cuts you should use a saw blade with at least 60 teeth.
14

MAINTENANCE

Don't clean or do maintenance on the machine while connected to the power supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out!
Malfunctions must be repaired immediately by trained persons.
14.1

Maintenance schedule

Loose or lost screws
Damage of any part
Saw blade condition
Readjust miter and bevel angle, laser;
Sharpen saw blade
Change saw blade
Change carbon brush
HOLZMANN Maschinen GmbH
Checks and activities to be performed
Clean machine
Empty dust bag
www.holzmann-maschinen.at
Zug-, Kapp-, Gehrungssäge / Profi mitre saw / Manual de instrucciones/Mode d´emploi
A C H T U N G
Prior to every operation
Prior to every operation
Prior to every operation
After every operation
After every operation
When necessary
When worn or defect
When carbon brush is worn ( < 4mm )
MAINTENANCE
monthly
Seite 36
KAP 255 XJL