Andis reVITE MTC Mode D'emploi page 5

16. WARNING: Never touch both terminals on clipper with
metal objects and/or body parts, as short circuit may
result. Keep away from children. Failure to comply with
these warnings could result in fire or serious injury.
17. Keep the appliance dry.
18. WARNING: During use, do not place or leave appliance
where it may be 1) damaged by an animal or 2) exposed
to the weather.
19. WARNING: For the purposes of recharging the battery,
only use the detachable supply unit provided with this
appliance.
20. WARNING: Oil blades frequently. Blades may become
hot after prolonged use.
21. This appliance is intended for trimming purposes only.
22. This appliance contains batteries that are only
replaceable by skilled persons.
SAVE THESE INSTRUCTIONS
REFER TO PAGE 2 FOR FIGURES.
OPERATING INSTRUCTIONS
• The battery must be removed from the appliance before it is recycled.
• The battery is to be recycled as a lithium-ion battery.
UNIVERSAL AC/DC POWER ADAPTER
1. Remove the wall adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage wall adapter and interchangeable
plugs for use in most countries around the world (Figures A-F).
3. To attach the desired plug to the wall adapter, align the slots on the plug to the ribs on the wall
adapter and slide into place. The plug will "click" into place when properly attached. To remove,
locate the button marked "push" on the wall adapter. Press the button and slide the plug from the
wall adapter. The plugs for the various countries all attach and remove using the same method
(Figure G).
4. Connect the power cord to the back of the charger and then insert the transformer into an
AC outlet.
CHARGING CLIPPER
The 5V 2.4A AC adapter is only intended for use with Andis Model MTC lithium-ion clipper.
Remove the clipper and AC adapter from the carton. Plug the AC adapter into a 100-240V, 50/60
cycle AC outlet, or as noted on the unit. Plug the adapter cord directly into the receptacle on the
bottom of the clipper (Figure H).
The clipper ON/OFF switch must be in the OFF position for the battery to charge (Figure I). The
charging indicator light on the clipper will turn red when the clipper is charging. When clipper is
fully charged, the red light will turn blue (Figure J).
5