Expert Mode - PROUSER LI300A Manuel D'instructions

JUMP-STARTING YOUR CAR (12V ONLY !)
NOTE: Read your car´s owner's manual! Some vehicle manufacturers have special
requirements before jumpstarting the vehicle (e.g. fuses that have to be removed or
certain security demands). Some vehicles manufacturers place the battery in the cargo
area or trunk. These vehicles often have designated jump-start terminals.
ATTENTION: After each failed attempt to jumpstart your car, take a break for at least 1
minute to avoid overheating.
1. Preparation: Make sure there's no oxide or dirt on the vehicle battery's terminal.
2. Open the dust cover (9) and connect the delivered set of jumper cables to the EC5
OUTPUT (8) port of the unit. Attention: Don´t touch or connect the red to the
black clamp.
3. Connect the red (+) clamp to your vehicle´s positive (+) battery terminal.
4. Connect the black (–) clamp to your vehicle´s negative (-) battery terminal (GND).
5. Make sure to have correct, good and reliable connections
6. Turn the unit on by pressing the START/MODE Button.
NOTE: If the car battery is absolutely discharged (voltage lower than 3V), the
device can not identify the battery and boost it (the battery is considered
broken).
7. Start your car.
NOTE: The device is powering off automatically after 1 Minute to prevent overheating.
Please start your car within that period.
8.
Remove the black and then the red clamp (Remember that the red and black clamp
must not touch) und disconnect the cables from unit´s EC5 OUTPUT (8)

EXPERT MODE

DANGER ! – EXPERT-MODE
(Only to be used by qualified persons! Exercise extreme caution!)
If the car battery is absolutely discharged (voltage lower than 3V), the device cannot
identify the battery and boost it (the battery is considered broken). In this case the
EXPERT-MODE can be activated by pressing the Manual Activation Button on the
protection box.
POLARITY PROTECTION ARE DEACTIVATED IN EXPERT-MODE !
WARNING: SHORT-CIRCUIT PROTECTION
5
AND REVERSE