MAPLE TABLETOP FIELD JOINT ASSEMBLY
1.
Lay top sections with field joint slots facing up on a
smooth, non-marring surface to protect top sections
from damage. (See Figure 8)
Figure 8
2. Push top sections together so surface sides are flush.
PAGE 4 OF 12
ASSEMBLY CONTINUED
3. Place a tite joint fastener (included) in each field
joint opening. (See Figure 9)
Figure 9
4. Using a 7/16" wrench, snug the tite joint fastener so
that both top sections are clamped together. Align
the faces and edges to be flush before completely
tightening the field joints. Gently adjust each section
with a piece of wood and rubber mallet to avoid
damage to the tabletop, then finish tightening.
5. Before turning tabletop over, see Top Assembly
instructions on page 3.
1-800-295-5510
uline.com
1122 IH-7606