Top Assembly - Uline H-7606 Mode D'emploi

Masquer les pouces Voir aussi pour H-7606:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TOP ASSEMBLY

NOTE: If you have a 72 x 48" Maple Tabletop,
see Maple Tabletop Field Joint Assembly on
page 4 before continuing to step 1.
1. To attach tabletop onto frame assembly, place
tabletop on a smooth, non-marring surface with top
side facing down.
2. Rotate assembled frame upside down and line up
two pre-drilled holes on back corners of tabletop.
Using four wood screws and drill with Phillips head
drill bit, attach frame to underside of tabletop.
(See Figure 5)
NOTE: Additional pre-drilled holes in tabletop
are used for a different product and will not
align with this frame. You must pre-drill your
own pilot holes.
Figure 5
Pre-drilled
holes
3. Using all other hole locations in frame as template,
drill 3/4" deep pilot holes into tabletop using 3/16"
drill bit. Using 18 (20 for 72" table) wood screws
and drill with Phillips head drill bit, attach frame to
underside of tabletop in these new pilot holes.
(See Figure 6)
NOTE: Wood screws for front and back of frame
are optional and provide more support.
PAGE 3 OF 12
ASSEMBLY CONTINUED
Pre-drilled
holes
Front
Tabletop
Figure 6
Wood
Screw
4. For Mobile Tables Only: Using a 17 mm wrench,
attach casters with four bolts, flat washers, lock
washers and nuts included in the caster pack.
Put casters in locking position. (See Figure 7)
Figure 7
5. Carefully set table upright and recheck all screws
for tightness.
Wood
Screw
Front
Tabletop
1122 IH-7606

Publicité

Table des Matières
loading

Table des Matières