Proper Usage - Matrix C50 CLIMBMILL Manuel D'utilisation

EMERGENCY STOP
EMERGENCY STOP
AUTO-STOP SENSOR
CONTROL ZONE

PROPER USAGE

MOUNTING THE CLIMBMILL
1. There are two EMERGENCY STOP BUTTONS on the ClimbMill.
One emergency stop button is located at the top of the
handlebars and the second is located on the lower right
side handlebar. The EMERGENCY STOP BUTTONS will bring
the step surfaces to a complete stop when pressed.
2. The CONTROL ZONE will bring the step surfaces to a
complete stop upon detecting an object. The AUTO-STOP
SENSOR will bring the step surfaces to a complete stop
upon detecting an object under the bottom step.
3. Stand directly behind the ClimbMill on the CONTROL
ZONE. Grasp the handlebars and step onto the ClimbMill
until you are within comfortable reach of the console, top
emergency stop lever, and in-reach handlebar controls.
4. To determine proper workout position, stand on the
steps within comfortable reach of the console. Maintain a
constant distance from the console and in-reach handlebar
controls. Keep your knees slightly bent at all times.
5. Dismounting the ClimbMill - After the steps have
come to a complete stop and while grasping the
handlebars, step down onto the CONTROL ZONE.
POWER
The power cord must be plugged into the power
socket, which is located in the front of the equipment
on the front of the machine. The power switch is
located next to the power socket. Make sure it is in
the on position. Unplug cord when not in use.
WARNING!
Never operate product if it has a damaged cord
or plug, if it is not working properly, if it has
been damaged, or immersed in water. Please
reference contact information on the back cover
of the INFORMATION CARD for assistance.
9