Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BASIC OPERATION
FREE AREA
0.6
CONTROL
ZONE
LEVELERS
8
LOCATION OF THE UNIT
Place the ClimbMill on a level surface. For ease of access, there should be an accessible space preferentially on both sides
and the rear of the ClimbMill that is at least 0.6 meters (24 inches). Do not place the ClimbMill in any area that will block
any vent or air openings. The ClimbMill should not be located in a garage, covered patio, near water or outdoors.
HEIGHT AND WEIGHT REQUIREMENTS
The equipment adds 20" – 25" (50 – 64.5 cm) to a user's height. For example, a 6'1" (185 cm)
tall user will be 7'9" – 8'2" (236 – 249 cm) off the floor. The C50 requires a minimum user
weight of 99 lbs (45 kgs) and has a maximum user capacity of 300 lbs (136 kgs).
FOOTPRINT:
(2
)
m
ft
HEIGHT:
WEIGHT:
MOVING THE EQUIPMENT
The ClimbMill has a pair of transport wheels built into the front of the frame. To move, first remove the power supply
and firmly grasp the Control Zone, carefully tilt and roll. Note: be sure to grab the steel frame and not the plastic.
LEVELING THE EQUIPMENT
It is extremely important that the levelers are correctly adjusted for proper operation. Turn leveling foot clockwise to lower
and counter-clockwise to raise unit. Adjust each side as needed until the equipment is level. Use of a level is recommended.
WARNING!
Our equipment is heavy, use care and additional help if necessary when moving.
Failure to follow these instructions could result in injury.
135 x 72 cm / 53" x 28"
190 cm / 75"
138.5 kg / 293 lbs.
Publicité
Table des Matières
