Control Panel Fault Messages - Dometic COOLAIR RTX 1000 Manuel D'installation Et D'utilisation

Parking Cooler
Display
Indication
When operating for the first time,
the battery symbol briefly flashes
— twice every 5 seconds. This
indicates an incorrect connection of
the battery sensor cable.

11 .2 Control Panel Fault Messages

Refer to this section when a fault message is observed.
Display Text
F01
The compressor does not work.
F02
F03
F04 The condenser fan 1 does not work.
F05 The condenser fan 1 is overloaded.
F06 The condenser fan 2 does not work.
F07 The condenser fan 2 is overloaded.
F08 The evaporator fan does not work.
F09 The evaporator fan is overloaded.
F10 N/A
F11
The system cannot determine the internal
temperature.
F12
F13
The system cannot determine the
external temperature.
F14
F15
The system cannot determine the
compressor temperature.
F16
F17 The compressor temperature is too high. Compressor thermal overload.
F18 Saved for future use.
F19 Saved for future use.
EN
Description
Description
Cause
The system cannot measure the
battery voltage.
Cause
An error in the compressor
sensor electrical supply (open
circuit) was detected.
The compressor is overloaded.
There is no response from the
fan.
The fan speed is faulty.
There is no response from the
fan.
The fan speed is faulty.
There is no response from the
fan.
The fan speed is faulty.
An error in the temperature
sensor electrical supply (open
circuit) was detected.
An error in the temperature
sensor electrical supply (open
circuit) was detected.
An error in the temperature
sensor electrical supply (open
circuit) was detected.
N/A
N/A
Display Messages
Remedy
Consult an authorized dealer
and have the battery connection
checked.
Remedy
• Switch off the system.
• Switch it on again after 30
minutes.
If the fault occurs again,
contact an authorized dealer.
• Switch off the system.
• Switch it on again after 30
minutes.
If the fault occurs again,
contact an authorized dealer.
N/A
N/A
21