hajdu ZV80ErP Instructions De Montage Et D'utilisation page 28

6.2. The current of the electric system has to be connected to the hot water
tank through an all-pole disconnection device, which has at least 3mm
separation distance in all pole.
6.3. The diameter of the required electric system wire is: 1.5 mm2 – 4 mm2,
depending on performance as described on the data table.
The wires adequate for connection to the electric system are the following:
Adequate type: Alternative type:
H0 5 VVK
H0 5 RRK
Connection with wire protection tube is not allowed!
6.4. To perform electric connection, take out the screws of the cover of the
fitting house and remove the cover, so that the electric fittings can be accessed.
The electric connection wire has to be connected to the screwed connecting
points of the temperature controlling/reducing device.
The protective conductor (green and yellow) has to be connected to the
earthing screw of the closing cover. The stripped wire end is placed under the
earthing washer and it is mounted with spring washer and screw nut.
The electric connection outline drawing can be seen on Figure 3. which can also
be seen on the cover of the fitting house.
6.5. The connecting wire has to be discharged with fixing the carriage at lead-
In after electric connection.
Touch protection class of the appliance: I.
The covers closing electric accessories provide suitable protection against
accidental touch of active electric parts being under power during operation.
Please, connect the appliance to the electric network according to the
connection diagram located both on the bottom sheet and in the usage manual
of the appliance. IT IS AT THE RISK OF DEATH AND THEREFORE IT IS FORBIDDEN
to install and operate the appliance without professional connection of touch
protection wire!
(H0 5VVF)
(H0 5RRF)
EN
27