hajdu ZV80ErP Instructions De Montage Et D'utilisation page 25

Pursuant to regulations of Hungarian Standards IEC 60364 / MSZ HD 60364,
the hot water storage must be installed and connected to pipeline and
electricity by a professional technician.
Before installation of the unit, a professional architect has to analyze the
structure of the wall where the unit will be mounted.
The following solutions are proposed in case of different wall types:
•
Stone, brick and concrete walls of thickness of 100-150 mm: hex head
bolts (Hungarian Standard M 12, MSZ EN ISO 4017), bolt washer for wood
connection (M 12). It is mounted with horizontal flat steel of 50 x 5 at the
back side of the wall.
•
Really thin walls: hex head bolts (Hungarian Standard M 12, MSZ EN ISO
4017), bolt washer for wood connection (M 12). Fixed with 2 U shaped
steels of 60 x 40 x 3 (MSZ EN 10279) vertically at the back side of the wall.
In case of wall mountable horizontal water tanks, an installation distance of at
least 70 cm has to be guaranteed on the side of the fitting area.
Wall mountable horizontal hot water tanks are delivered in factory adjusted
"left design", mounted ready (see Figure 1)
Check the placement of the suspension legs. If this installation placement is
suitable, then there is nothing left to do, except for mounting the unit on the
bolts fixed on the wall and fix the unit with bolt washers, bolt nuts. Before
mounting the unit, check the tension of the mounting bands, and tighten the
screws fixing the bands placed on the front of the hot water tank, if necessary.
If the distance between the screws fixed in the wall and the distance of
suspension legs fixed to the unit are different, then the followings should be
done:
1. Loosen the screws fixing the bands (placed on the front of the hot water
tank) and set the bands together with the suspension legs either closer or
farther. Take care that the supporting plate under the suspension legs should
remain under the suspension legs in this new placement, as well.
2. Tighten the screws and lay the hot water tank on a floor being in the same
plane as the suspension legs.
EN
24