Miles Industries Valor G3 Serie Guide D'installation

INSTALLATION INSTRUCTIONS
FenderFire Single Door Front 744FVI
Approved for use with Valor models 738/739 ONLY
DANGER
!
A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and must be
installed for the protection of children and other at-risk
individuals.
The 744FVI FenderFire Single Door Front
is designed to be used along with an outer
surround trim (supplied separately).
The Single Door Front fits within the outer
surround trim and clips onto the standard
mounting brackets supplied with the 738/739
heaters.
The Single Door Front is compatible with all
outer surround trims and cast iron surrounds
available for use with the 738/739 heaters.
For the double door version of the FenderFire
front, refer to the 743FVI FenderFire install
instructions.
4000628-11
© Copyright Miles Industries Ltd., 2022
G3 Series
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Clip-on window trim
Screen Door
(drop onto
hinge pins)
Overview (Heater and Outer Surround Trim sold separately)
(clips on appliance below
Extension Baffle 738 BV ONLY
draft hood) (discard for
(clips on appliance below draft
hood) (discard for 739)
(drops into place)
Magnet
INSTALLER: Leave this
manual with the appliance.
CONSUMER: Retain this
manual for future reference.
Note: This kit must be
installed or serviced by a
qualified installer, service
agency or gas supplier.
These instructions are to be
used in conjunction with the
main installation instructions
for the above listed heater
model.
Outer Surround Trim
supplied separately
(clips onto brackets)
Mounting Brackets
supplied with
Mounting Brackets
supplied with 738,
Clearance Kit 739 appliances