Toro Power Max Heavy Duty 928 OAE Mode D'emploi page 22

Figure 26
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and
adjust or replace it if necessary.
1. Remove the 2 screws that are holding the belt
cover in place (Figure
2. Remove the belt cover
Figure 27
3. With the auger/impeller lever disengaged,
ensure that the gap between the auger clutch
arm and the frame of the machine is 1.5 mm
(1/16 inch) as shown in
g001021
2. Turnbuckle
27).
(Figure 27).
g260066
Figure 28.
1. 1.5 mm (1/16 inch)
2. Frame
4. If the auger/impeller cable is not properly
adjusted, do the following steps:
5. Loosen the jam nut
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed
on the belt cover.
10. If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
Service Dealer.
20
Figure 28
3. Auger clutch arm
(Figure 29).
Figure 29
2. Turnbuckle
(Figure 29).
g260108
g322960