Replacing Light Bulbs - DCS RX215 Guide D'utilisation

Replacing light bulbs

Electric Shock Hazard
Disconnect power to refrigerator before replacing light bulb. After replacing
light bulb, reconnect power.
Failure to do so can result in death or injury to persons.
Caution!
To avoid personal injury or property damage, observe the following:
Before handling, allow light bulb to cool once refrigerator has been turned off.
Wear gloves when replacing light bulb.
Upper fresh food section
The upper fresh food light bulbs are located behind the front
panel. Reach behind the panel to remove the bulbs.
Lower fresh food section and upper freezer section
Push up on bottom tabs of light cover. Rotate cover up and
1
release tabs.
Remove light bulb. Replace bulb with an appliance bulb no
2
greater than 40 watts.
Insert top tabs of light cover into liner slots and snap bottom
3
tabs into liner slots.
Lower freezer section
Pinch both sides of light cover to remove.
1
Remove light bulb. Replace with appliance bulb no greater
2
than 40 watts.
Pinch both sides of the light cover to snap into place.
3
4293_USA_DCS_EN_FR_SidebySide_Ref_UG6.indd 25
Care and cleaning
WARNING!
25
Fig.18 Light in lower
fresh food section and
upper freezer section
18/9/09 11:06:32 AM
US
CA