Water Filter; Initial Installation - DCS RX215 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Water filter

US
18
CA
Water filter removal and installation
Poisoning Hazard
To avoid serious illness or death, do not use the refrigerator where water is
unsafe or of unknown quality without adequate disinfection before or after
use of filter.
Failure to do so can result in death or injury to persons.
Important!
After installing a new water filter, if removing the filter for any reason, do so with caution as air
trapped in system may cause water and cartridge to eject.
The bypass cap does not filter water when fitted. Be sure to have replacement cartridge available
when filter change is required.
If water filtration system has been allowed to freeze, replace filter cartridge.
If the ice maker has not been used for several months, or ice has an unpleasant taste or odor,
empty and wash the ice bin in warm soapy water, rinse and dry before replacing. If unpleasant
taste or odor persists, change filter cartridge.

Initial installation

The water filter is located in the upper right-hand corner of the fresh food compartment.
Open filter housing by pressing the tab at the front end of the housing.
1
Remove the blue bypass cap and retain for later use.
2
Remove the sealing label from end of filter and insert into filter head.
3
Rotate gently clockwise until filter stops. Snap filter cover closed.
4
Fig.16 Filter housing and bypass cap
4293_USA_DCS_EN_FR_SidebySide_Ref_UG6.indd 18
WARNING!
Fig.17 Filter housing and filter
18/9/09 11:06:26 AM

Publicité

Chapitres

Table des Matières
loading

Table des Matières