AENO EG1 Mode D'emploi page 10

Press the "Start" button. The current temperature will be displayed, and the
countdown timer will be started.
NOTE that is you do not press the "Start" button, the grill will be switched to
the standby mode in 30 minutes, and the "OFF" message will be displayed.
At the end of the countdown, an audible signal will sound for 5 times. The
"DONE" message will be displayed.
See below the LED indication of the grill's modes (See Figure c):
LED colour
Blue
Green
Yellow
Red
When you finished with cooking, press the "Cancel" button and unplug the
grill. Wait for the grill to cool down, then carefully remove the drip tray ❽ and
pour its contents down the drain. Don't forget to wash the removable plates
and the drip tray with warm soapy water.
Troubleshooting
1. The grill does not turn on. Possible causes and solutions: Make sure that
there is no power supply failure in the mains socket (e.g. plug any known
good device into it) and that the grill is correctly plugged into the mains
socket.
2. The grill is switched on, but removable plates do not heat up. Possible causes
and solutions: Make sure that you set both the operating time and the
temperature and that the "Start" button was pressed.
3. The control panel does not light up. Possible causes and solutions: Unplug
the grill, let it cool down, and plug it in again.
10
Grill mode
Preheating is on
Preheating is finished
Cooking is on
Cooking is finished
aeno.com/documents