Hatco Flav-R-Savor FSHC-5W Série Manuel D'installation Et D'utilisation page 15

English
Countertop Platform
A countertop platform option is available to allow installation of
a unit directly to a countertop. Use the following procedure to
install the countertop platform.
1. Remove the pan slides and reservoir cover from inside the
cabinet and drain the water reservoir, if necessary.
2. Carefully lay the unit on its back side. This step requires
two people.
NOTE: Place a piece of cardboard between the cabinet and
the floor to prevent marring the cabinet finish.
3. Remove the mounting screws and casters on each corner
of the unit, if installed.
4. Reinstall all the mounting screws directly into the bottom of
the unit except the inside screw along the edge of the unit
at each corner (see illustration). Only one screw at each
corner is needed for installation.
5. Using the four remaining mounting screws, install the
countertop platform to the bottom of the unit. Tighten securely.
Countertop
Platform
Mounting
Screw
Position front edge
of platform flush with
front edge of countertop.
Installing the Countertop Platform
6. Return the unit to its upright position. This step requires
two people.
7. Place the unit on the countertop. This step requires at least
two people. CAUTION! Do not lift unit by countertop
platform. Platform has edges that may cause injury.
• To maintain proper access to the drain hose, position
the front edge of the platform flush with the front edge
of the countertop.
8. Seal the unit to the countertop using a NSF-approved
(National Sanitation Foundation) silicone sealant.
9. Replace the pan slides and reservoir cover inside the
cabinet.
Form No. FSHC7WM-1119
OPTIONS AND ACCESSORIES
Bumper Assembly
A bumper assembly option is available for installation on the
bottom of a unit. The bumper assembly provides protection to
the unit and surrounding wall surfaces while it is being moved.
Use the following procedure to install the bumper assembly.
1. Remove the pan slides and reservoir cover from inside the
cabinet and drain the water reservoir, if necessary.
2. Carefully lay the unit on its back side. This step requires
two people.
NOTE: Place a piece of cardboard between the cabinet and the
floor to prevent marring the cabinet finish.
3. Remove the mounting screws and casters on each corner
of the unit, if installed.
4. Using two of the mounting screws at each corner, install
the bumper assembly to the bottom of the unit. Tighten
securely.
5. Install the casters onto the bumper assembly.
To install the casters on each corner of the bumper assembly:
a. Remove the four mounting nuts from the threaded
posts.
b. Place the caster onto the threaded posts.
c. Install the four mounting nuts on the threaded posts.
Tighten securely.
NOTE: Install the two swivel casters on the front of the unit and
the two stationary casters on the back of the unit.
6. Return the unit to its upright position. This step requires
two people.
7. Replace the pan slides and reservoir cover inside the
cabinet.
Bumper
Assembly
Mounting
Screw
Swivel
Caster
Stationary
Caster
Mounting Nut
Installing the Bumper Assembly
Pan Slides
Additional stainless steel pan slides are available as
accessories. Use additional pan slides to increase the pan
capacity of the unit when the height of the pans/product allow.
15
Threaded
Post