Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
ELECTRICAL SAFETY
WARNING! Do not touch or handle a live tool with any part
of your body that is wet or damp. Wet skin reduces
resistance to electrical current, increasing the danger of a
serious or fatal shock.
WARNING! To reduce risk of electric shock, be certain that
the plug is connected to a properly grounded receptacle.
1.
Do not alter any parts of the tool or accessories. All parts and
accessories are designed with built-in safety features that may be
compromised if altered.
2.
Protect yourself against electric shocks when working on electrical
equipment. Avoid body contact with grounded surfaces. There is
an increased chance of electrical shock if your body is grounded.
3.
Do not expose the mitre saw to rain, snow, frost or any other damp
or wet conditions. Water entering a tool will increase the risk of
electric shock.
4.
Do not disconnect the power cord in place of using the power
switch. This will prevent an accidental start-up when the power
cord is plugged into the power supply.
5.
In the event of a power failure, turn off or unplug the machine as
soon as the power is interrupted. The possibility of accidental
injury could occur if the power returns and the unit is not switched
off.
6.
Make certain the power source conforms to requirements of your
equipment (see Specifications).
7.
This tool is only for use on 120 V (single phase) and is equipped
with a three-prong grounded power supply cord and plug. Check
with a qualified electrician if you are in doubt as to whether the
outlet is properly grounded. If the tool should electronically
malfunction or break down, grounding provides a low resistance
path to carry electricity away from the user.
a.
Never remove the grounding prong or modify the plug in any
way, as this will render the tool unsafe.
b.
Do not use any adapter plugs.
Page 9
2-SPEED SLIDING MITER SAW
Assistance available at www.princessauto.com or 1-800-665-8685
8987646
Publicité
Table des Matières
