Assembly And Installation - PRO-POINT 8987646 Mode D'emploi

8987646

ASSEMBLY AND INSTALLATION

The mitre saw can be used as a portable unit or fixed to a workbench.
You can also install this tool on a mitre saw stand.
MOUNT THE MITRE SAW ON A WOOD
WORKBENCH
The hardware to mount the tool is not included.
1. Clean the work area where the tool will be mounted.
2. Position the mitre saw. Check that it is level and there are no
obstructions around it that will interfere with a long workpiece.
3. Slide a flat washer over a 1/4 x 1 in. wood screw, insert the screw
through a corner hole in the base and secure the base.
4. Repeat with three more screws. Tighten all screws until the gap
between the mitre saw base and the bench top is 1/8 in.
FREESTANDING UNIT
1. Pull the anti-tilt brace out from the
base and secure it with an Allen
key (fig. 2).
2. Position the mitre saw. Check that
it is level and there are no
obstructions around it that will
interfere with a long workpiece.
3. Extend the front leg screw until it
touches the surface (Fig. 3-1).
Make sure the mitre saw does not
wobble. Continue to adjust the
screw to level the rotating table.
BLADE INSTALLATION
WARNING! To prevent an accident or personal injury, always
turn off the trigger switch and disconnect the power source
before removing or installing the blade.
Handle the circular saw disc with care during installation and removal.
Assistance available at www.princessauto.com or 1-800-665-8685
2-SPEED SLIDING MITER SAW V1.0
Fig. 2
Fig. 3
Page 12