Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
Contact your local municipality for a list of disposal facilities or by-laws
for electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
Problem(s)
The mitre saw
will not start.
Motor starts
slow and doesn't
reach operation
speed.
Page 21
2-SPEED SLIDING MITER SAW
Possible Cause(s)
1.
Supplied power is
interrupted.
2.
Brushes are worn or
sticking.
3.
Fuse or breaker
tripped.
4.
On/Off switch is
faulty.
5.
Motor components
are short-circuiting
or are defective.
6.
Motor has
overheated.
7.
Power cord
damaged.
1.
Voltage is too low
2.
Motor is damaged.
Assistance available at www.princessauto.com or 1-800-665-8685
Suggested Solution(s)
1.
Check that power supply is still
available.
2.
See Carbon Brush Maintenance.
3.
Replace fuse or reset breaker.
4.
Replace faulty switch.
5.
Have a qualified technician
service the tool.
6.
Allow motor to cool before
attempting to use.
7.
Replace damaged power cord.
1.
Confirm power source amps and
voltage matches or exceeds
those of the mitre saw. Remove
other tools or devices on the
same electrical circuit.
2.
Have a qualified technician
service the tool.
8987646
Publicité
Table des Matières
