Installation/Connection; Basic Procedure; Warning; Caution - Kenwood KDC-MP102U Mode D'emploi

Symptom
"NO MUSIC" appears.
"NA DVICE" appears.
"USB ERR" appears.
Noise is generated.
Tracks cannot play back as you have
intended them to play.
"READING" keeps flashing.
Elapsed playing time is not correct.
Correct characters are not displayed (e.g.
album name).

Installation/connection

Part list:
A Faceplate.............................................................. (×1)
B Escutcheon ......................................................... (×1)
C Mounting sleeve ............................................. (×1)
D Wiring harness .................................................. (×1)
E Removal tool ..................................................... (×2)
F Flat head screw (for Nissan cars) ........... (×4)
G Round head screw (for Toyota cars) .... (×4)

Basic procedure

1 Remove the key from the ignition
switch, then disconnect the · terminal
of the car battery.
2 Make proper input and output wire
connections.
\ "Wiring connection" (page 13)
3 Install the unit to your car.
\ "Installing the unit" (page 14)
4 Reconnect the · terminal of the car
battery.
5 Reset the unit. (page 3)
12
The connected USB device contains no playable audio file.
Connect a supported USB device, and check the connections.
Remove the USB device, turn the unit off, then turn it on again. If the unit still
showing the same display, try to connect another USB device.
Skip to another track or change the disc.
Playback order is determined when files are recorded.
Longer readout time is required. Do not use too many hierarchies and folders.
This is caused by how the tracks are recorded.
This unit can only display letters (upper case), numbers, and a limited number of
symbols.

Warning

The unit can only be installed in a car with
a 12 V DC power supply, negative ground.
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit,
that in turn may start a fire. Always connect
those wires to the power source running
through the fuse box.
Disconnect the battery's negative terminal
and make all electrical connections before
installing the unit.
Insulate unconnected wires with vinyl tape
or other similar material. To prevent a short
circuit, do not remove the caps on the ends
of the unconnected wires or the terminals.
Be sure to ground this unit to the car's
chassis again after installation.

Caution

If your car's ignition does not have an ACC
position, connect the ignition wires to a
power source that can be turned on and
off with the ignition key. If you connect
the ignition wire to a power source with
a constant voltage supply, as with battery
wires, the battery may die.
Do not use your own screws. Use only the
screws provided.
Remedy/Cause