Installation/Connection; Basic Procedure - Kenwood KMM-BT508DAB Mode D'emploi

Installation/Connection

This section is for the professional installer.
For safety's sake, leave wiring and mounting to professionals. Consult the
car audio dealer.
WARNING
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car
chassis or Ground wire (black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires
that comes into contact with metal parts to protect the wires.
CAUTION
• Install this unit in the console of your vehicle. Do not touch the metal parts
of this unit during and shortly after use of the unit. Metal parts such as the
heat sink and enclosure become hot.
• Do not connect the wires of speakers to the car chassis or Ground wire
(black), or connect them in parallel.
• Mount the unit at an angle of less than 30°.
• If your vehicle wiring harness does not have the ignition terminal, connect
Ignition wire (red) to the terminal on the vehicle's fuse box which provides
12 V DC power supply and is turned on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers,
etc. on the car are working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis,
then replace the old fuse with one that has the same rating.
30
ENGLISH
Part list for installation
(A) Faceplate (×1)
(C) Mounting sleeve (×1)
(E) Extraction key (×2)

Basic procedure

1
Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Install the DAB antenna.
See "Installing the DAB antenna" on page 33.
3 Connect the wires properly.
See "Wiring connection" on page 32.
4
Install the unit to your car.
See "Installing the unit (in-dash mounting)" on page 31.
5
Connect the terminal of the car battery.
6 Press B SRC to turn on the power.
7
Detach the faceplate and reset the unit within 5 seconds. (Page 3)
(B) Trim plate (×1)
(D) Wiring harness (×1)