Operating Modes; Dry Mode - Danby DPA072B8WDB-6 Manuel Du Propriétaire

OPERATING INSTRUCTIONS

OPERATING MODES

Cool Mode
Choose cool mode to set the cooling function.
• Use the temperature control buttons to choose
the desired temperature.
• Use the fan button to choose the desired fan
speed.
• The temperature can be set within a range of 17
- 30°C (62 - 86°F).
• The exhaust hose should be installed during cool
mode to ensure the best results.

Dry Mode

Choose dry mode to remove excess moisture from
the air. Water will condense inside the appliance
and drain out the back.
• The humidity level and fan speed will be
automatically set and cannot be modifi ed in dry
mode.
• The exhaust hose does not need to be installed
during dry mode.
• It may be necessary to install the continuous
drain hose during dry mode to remove excess
water.
OPERATING MODES
Fan Mode
Fan mode can be used to run the fan without
engaging the cooling or dehumidifying functions.
• Press the fan button to choose the desired fan
speed.
• The exhaust hose does not need to be installed
during fan mode.
• In cooling or dry mode, press and hold the
fan button for 3 seconds to set the fan to run
continuously. Press and hold the fan button for 3
seconds to disengage the continuous fan. During
normal operation the fan will turn on and off
with the compressor.
Auto Mode
Auto mode is a pre-set factory program that
automatically defi nes the mode (cool or fan) and
fan speed based on the set temperature and the
ambient temperature. The exhaust hose should be
installed during auto mode.
16