Maintenance And Storage; Cleaning The Fi Lters; Storing The Robotic Cleaner; Checking Water Outlet Propeller - Pentair PROWLER P Serie Guide D'installation Et D'utilisation

MAINTENANCE AND STORAGE

Cleaning the fi lter(s)
The two fi lter(s) must be cleaned after each cleaning cycle. Press the button to release the fi lter and pull it out of
the cleaner. Open the fi lter case. Spray water on the outer sides of the fi lter and then spray water towards the inner
side of the fi lter to clean all the dirt and debris. Reinsert the fi lter back into its location.

Storing the robotic cleaner

Follow these instructions to store the robotic cleaner when not in use: Disconnect the power cord from the wall
outlet. Disconnect the fl oating cable from the power supply. Make sure that the power supply is not exposed to
water Spread out the fl oating cable, and roll it. Wash the cleaner unit interior space with fresh water and let it dry.
Roll the fl oating cable and place it on the cleaner unit. Caution: Do not roll the fl oating cable on the handle of the
cleaner unit. Store the robotic cleaner components in a dry, closed location.
1
4

Checking water outlet propeller

It is recommended to periodically clean debris and hair from the propeller of the water outlet: Remove the fi lter(s).
Remove the screws that hold the water outlet cover. Remove the water outlet cover. Clean any hairs, dirt, or debris.
Return the cover and fasten it with the screw. Reinsert the fi lter(s).
For warranty conditions and spare parts view, please check www.pentairpooleurope.com
2
5
PROWLER P-SERIES Robotic Inground Pool Cleaner Installation and User' s Guide
3