Amana TRI18TL Manuel D'utilisation page 5

A. End cap
C. End Caps
Handle removal
• Remove end cap from top of freezer handle using a
screwdriver with the blade covered with masking
tape. Remove one top and two bottom mounting
screws.
2. Remove top hinge cover. Top hinge cover snaps off.
Remove top hinge and shim using hex nut driver.
3. Lift freezer door off center hinge.
4. Lift door closure off center hinge pin. Remove center
5
hinge pin with / " or
16
5. Remove refrigerator door by lifting off bottom hinge.
6. Remove center hinge bracket and shim using Phillips
screwdriver.
7. Remove toe grille and bottom hinge cover. Both snap
off.
8. Remove bottom hinge and shim using hex nut driver.
B
or
C
B. handle screws
9
/ " hex nut driver.
32
A
J
I
H
A. 5/16" screws
C. 5/16" hex nut
E. Center hinge bracket
G. 3/8" screws
I. Center hinge
Hinges
9. Reverse doors by performing the following steps:
• Replace bottom hinge and shim on opposite side of
cabinet.
• Remove button plugs from center mullion. Place
button plugs in holes left when center hinge bracket
was removed. Rotate center hinge bracket 180° and
install center hinge bracket on opposite side of
cabinet with hinge screws. Reuse plastic hinge pin
washers.
• Remove door stop from refrigerator and freezer
doors with a Phillips screwdriver. Install door stop
on opposite side of door.
A. Door stop
Door stop
• Place refrigerator door on bottom hinge. Install
center hinge pin in center hinge bracket. Place door
closure on center hinge pin.
• Remove button plugs from top of refrigerator
cabinet. Replace button plugs in holes left when top
hinge was removed. Remove hinge hole cover from
freezer door. Replace on opposite side of freezer
door.
5
A
B
D
C
F
G
B. Door closure
D. Center hinge pin
F. Phillips screws
H. Bottom hinge
J. Top hinge
E
A