Sauder Computer Credenza 404944 Mode D'emploi page 17

Step 12
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (I2) to the RIGHT END (A) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Peel the FELT DISC from the FELT DISC CARD (ZZ). Stick
å
the FELT DISC on the DOOR where it comes in contact
with the RIGHT UPRIGHT (C).
Fasten a BACKPLATE (UUU) and KNOB (TTT) to the
å
DOOR (I2). Use a BLACK 1-1/8" MACHINE SCREW (HHH).
See the next step for DOOR adjustments.
å
www.sauder.com/services
Mounting screw
A
C
HHH
BLACK 1-1/8" MACHINE SCREW
(1 used in this step)
404944
Stop
ZZ
I2
ZZ
TTT
UUU
Page 17