Sauder Computer Credenza 404944 Mode D'emploi page 9

Step 4
Separate the WIDE EXTENSION SLIDES (EE) from the WIDE EXTENSION RAILS (DD) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (DD) to the RIGHT UPRIGHT (C) and the other surface of the LEFT UPRIGHT (D). Use
å
four GOLD 5/16" FLAT HEAD SCREWS (PPP).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Open end
www.sauder.com/services
EE
Push the release lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
Wide
DD
D
Finished edge
DD
PPP
(4 used in this step)
DD
404944
Open end
C
Finished edge
Page 9