Publicité
Step 2
Separate the EXTENSION SLIDES (Z) from the EXTENSION RAILS (Y) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten an EXTENSION RAIL (Y) to the LEFT END (B) and UPRIGHT (C). Use
å
four GOLD 5/16" FLAT HEAD SCREWS (QQ).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL out
to fi nd the other hole that lines up with the hole in the END. Turn a SCREW
into this hole.
Fasten the CABINET RIGHT (40CA) and CABINET LEFT (40CB) to the LEFT
å
END (B) and UPRIGHT (C). Use four GOLD 5/16" FLAT HEAD SCREWS (QQ).
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Curved edge
Roller end
Page 6
Z
Push the black lever in and pull the SLIDE from the RAIL.
QQ
4
3
2
1
B
Open end
Curved edge
1
2
3
4
C
Y
Hole
408761
Remember:
Righty tighty.
Lefty loosey.
Y
Roller end
Open end
Y
www.sauder.com/services
Publicité
