Publicité
Step 10
Carefully turn your unit over onto its front edges. Lay the
å
BACKS (J and K) over your unit.
Make equal margins along all four edges of the BACKS (J
å
and K). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACKS (J and K) to your unit using the NAILS (RR).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (D).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
Page 14
Cut-out
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(44 used in this step)
These holes must line up
over the UPRIGHT (D).
J
K
408761
RR
NAIL
www.sauder.com/services
Publicité
