Jets Operation - Balboa TP600 Manuel D'utilisation

HOW TO USE YOUR SPA ENG
of the filter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when
Filter Cycle 2 is programmed to begin.
The Meaning of Filter Cycles
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the filter cycle
3. Purges happen at the start of each filter cycle
* For example, if your spa is set up for 24/hour circulation except for shutting off when the water
temperature is 3˚F/1.3˚C above the set temperature, that shutoff does not occur during filter
cycles.

5.6. JETS OPERATION

The water jets provide a hydrotherapy pressure jet. It is a closed circuit, where the water is
absorbed by 1 or 2 pumps (depending on the SPA model) through the drain and driven to the jets.
The hydromassage effect is provided by the jet, when the circuit water mixes with the outside air,
in the so-called Venturi effect.
To adjust the amount of air driven into the jets, simply turn the air input tab (venturis) as follows.
Each air inlet activates a certain group of jets.
Some jets can also adjust the flow intensity on opening and closing the water flow. To do this,
proceed as follows:
ATTENTION!
Do not attempt to forcibly turn the outer ring of the jet, as you could damage it.
29