Rimage Everest III Mode D'emploi page 28

3. Remove the print ribbon from the carrier.
a. Slide the supply roll to the left.
b. Slide the take-up roll to the right.
c. Discard the used print ribbon.
Install the Print Ribbon
1. Remove the new print ribbon from the packaging.
2. Install the print ribbon on the print ribbon carrier.
a. With the supply roll on the left
side, unwind several inches of
the print ribbon.
b. Lay the print ribbon across the
tacky roller and guide rollers.
c. Install the supply roll as shown.
d. Install the take-up roll as shown.
e. Rotate the take-up roll clockwise so the ribbon is aligned and lies flat.
Tip: You may need to lift the
ribbon up from the tacky roller to
straighten it.

Notes:
•
Do not rotate the ribbon past
the Cleaning Bars at the front
of the ribbon (Everest 600
only).
•
If you installed a monocolor
ribbon, advance the ribbon so
the ink portion of the ribbon is
advanced to the take-up roll.
2000621_B
All manuals and user guides at all-guides.com
Supply Roll
Supply Roll
Maintain the Everest Printer
Tacky Roller
Take-up Roll
Guide Rollers
Take-up Roll
Take-up Roll
27