Rimage Everest III Mode D'emploi page 12

Rimage Everest™ III and 600 User Guide
Label Design Requirements
The Everest printer Windows-compatible software ships with the CD Designer™ label editor software. This software is
installed on your PC during a typical installation of the Rimage software. If you have a Windows-based PC, you can use CD
Designer to design your labels.

Note: CD Designer is not Macintosh-compatible and will not be installed with the Macintosh-compatible Rimage software.
If you are using a Macintosh, or prefer to design labels in a software application other than CD Designer, use the following
criteria.
•
Label design size – Design labels with a height of 12 cm and width of 12 cm. A full-size disc is 120 mm (4.723") in
diameter. The hole is 15 mm (0.59"). The printable area and hub sizes vary depending on the disc manufacturer.

Note: The media that are in Rimage Media Kits have a printable area of 118-24 mm. On most labels, print settings of
118 mm and 24 mm are recommended.
Printable
Area 118 mm
•
File format – For best results, save your labels as JPEG or TIFF files. However, if you are using the Everest printer on
a Rimage autoloader, these file formats must be imported into CD Designer and saved as CD Designer files (.btw) or
converted to PDF files before printing.
•
Color mode – If your Everest printer is on a Rimage autoloader, convert all labels to the RGB color mode in order to
import them into CD Designer. If the Everest is a standalone printer or on an AutoEverest AutoPrinter, and you are printing
directly from an image-editing program, you can work in the color mode of your choice.
•
Resolution (pixels per inch) – For best results, use images set to a minimum of 300 pixels per inch. For the Everest 600,
you may notice better results if you use images with 600 pixels per inch or higher.
Print Requirements
Any label you create and save through CD Designer is in the correct file format (.btw) for printing to an Everest on a Rimage
autoloader. You can also print labels saved as PDF files if your Everest is on a Rimage autoloader.
If you are using a standalone Everest printer or an AutoEverest AutoPrinter, you can print directly from any application with
print capability.
10
All manuals and user guides at all-guides.com
Hub Size
24 mm
2000621_B