Publicité
Les langues disponibles
Les langues disponibles
Limitations
• A maximum of only one Programmer may be connected
to the PC at any one time.
• Only one decoder may be connected to the Programmer
at any one time.
Connecting a Decoder with a 21-Pin Interface Connector
• Plug the decoder into the interface connector on the ad-
apter (see drawing on Page 18).
• Make sure that nothing is connected to the remaining
connections on the adapter.
Connecting a Decoder with a 8-Pin Interface Connector
• Connect the decoder with the 8-pin plug to the adapter
(see drawing on Page 18).
• Also, connect the blue wires (marked with yellow or
orange) to the corresponding set screw terminals on the
Adapter.
• Make sure that no other decoder is connected to the 21-
Pin interface connector.
Connections for a Decoder without an Interface Connector
• Connect the 5 wires to the corresponding terminal clips
(see drawing on Page 18). Additional connections are not
required.
• Make sure that the 21-Pin interface connector and the
8-Pin interface connector remain unoccupied.
Note:
We recommend setting up the programmer together with
the decoder to be programmed flat on a table during the
programming. An additional USB extension cable is then
required for the connections.
Disposal
Notes on environmental protection: Products marked with a
trash container with a line through it may not be disposed of
at the end of their useful life in the normal household trash.
They must be taken to a collection point for
the recycling of electrical and electronic
devices. There is a symbol on the product,
the operating instructions, or the packaging
to this effect. The materials in these items
can be used again according to this marking.
Help us to protect the environment and
conserve resources and bring this device to
a corresponding disposal point/dealer free
of charge. For disposal-related queries, contact the organ-
isation responsible for waste disposal or your specialist
retailer.
www.maerklin.com/en/imprint.html
5
Publicité
