gdw 1278 Guide Rapide page 5

Hyundai Coupé
2000 - 2001
Ref. 1278
Fitting instructions
1) Remove the inner coating in the trunk, disassemble the bumper and loosen the exhaust from the support,
in the rear.
2) Remove the bumper supports from the buffer beam. Make afterwards at the bottom and in the middle of
the buffer beam an incicison of 220mm wide and 90mm measured from the lower rim. Also make an
incicison in the bumper : 160mm wide and 70mm measured from the lower rim.
3) Place the tow bar against the buffer beam so that the points (C) match the holes with which the bumper
supports were fastened. Insert the bolts and washers and tighten firmly. Place the bumper over the buffer
beam.
4) Bring the tow bar with bumper in the chassis so that points (A) and (B) match the provided openings in
the chassis beam. Place the mounting pieces (-e) and (-f) against the chassis beam, insert the bolts and
tighten firmly.
5) Refasten the exhaust on the provided piece on the tow bar.
6) Assemble (*) and tighten firmly.
Composition
Tow bar reference 1278
1 ball T43M002
4 bolts M12x40
4 security washers M12
6 bolts M10x40
6 security washers M10
8 bolts M8x30
8 security washers M8
8 washers ø25x8x2
8 nuts M8
1 mounting piece (-e)
1 mounting piece (-f)
1 security shackle
All bolts and nuts : quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*)
(*)
(A-B)
(A-B)
(C)
(C)
(C)
(C)
(A-B)
(A-B)
(*)