Preliminary Operations - Jacuzzi J-Sha MI Emploi Et Entretien

A B
4
1
45°
2
5
6
C D E
Tap fixtures
I (fig. 4) The tap fixtures are located on the side of the tub
and include:
• (A) Drain column control
When turned clockwise, the tub drain is closed.
• (B) Shower head
(fig. 5) To extract it, press on the ring nut and turn as indicat-
ed, and with the other hand pull the grip up. Do the same thing
to retract the hose and to put the shower head back in place.
• (C) Spout
Fills tub with water; (fig. 6) to send water to the shower head,
raise the indicated lever. After using the tub, make sure the
lever is down.

Preliminary operations

FILLING
I
Before filling the tub, make sure that the lever on the rear of
the spout is down (fig. 6); to make it easier to get into and out
of the tub, the spout can be turned in two directions, as shown.
I
Then use the knobs to control the temperature of the water.
Once you are in the tub, the water must completely cover the
outlets located on the back.
I
Provide power using the switch installed on the tub's power sup-
ply line.
SOME SUGGESTIONS
I
(fig. 7) Also make sure that the hydromassage jets are point-
ing towards the parts of the body that you wish to massage;
this can be achieved by simply moving the nozzle.
The jets on the back are not directionally adjustable.
I
(fig. 8) You can also vary the intensity of the hydromassage
cycle by adjusting the hydromassage outlet nozzles situated
along the edge of the tub, until one or more jets are complete-
ly closed.
The jets on the back are not directionally adjustable.
I
The length of the hydromassage cycle and the water tem-
perature are, however, matters of personal preference, related
to the type of treatment and the physical condition or habits of
the individual. Here are some recommendations:
16