Beyerdynamic AVENTHO WIRELESS Manuel page 9

Aventho wireless – Headphones
Turning on / off
The functions listed below refer to the Aventho wireless when it has already been paired
with a device with Bluetooth
• Turning on:
Hold down the button
The LED will illuminate red once.
• Turning off:
Hold down the button
The LED will illuminate red once and then go out.
Pairing with the player
Before you use the Aventho wireless for the first time, you have to pair it with your mobile
phone or another device with Bluetooth
be different with various players. Please refer to the appropriate manual of the player.
• When the Aventho wireless is turned off, press the button
®
the Bluetooth mode. The LED
• Activate the Bluetooth
devices.
• Select "beyerdynamic Aventho wireless" under the available devices in the Bluetooth
menu of your player and pair both devices. Each time when turning on, both devices
are paired automatically.
Alternatively, you can connect the Aventho wireless with an NFC-capable playback device
through NFC. The Aventho must be switched on. It does not matter whether the Aventho
is in pairing mode or not.
• Activate the NFC function on your playback
device so that all necessary information can be
transmitted to the playback device and a connec-
tion can be established.
• Hold the playback device to the left headphone
housing so that the two NFC chips are close to
each other. If required, test this by sliding move-
ments.
®
wireless technology.
for approx. 2 seconds.
for approx 6 seconds.
® wireless technology. The pairing process may
will rapidly flash blue and red in turns.
®
function on your player and, if necessary, search for new
for 6 seconds to start
9
®