Espresso Side - Hamilton Beach FlexBrew Mode D'emploi

Troubleshooting –
No power.
•
Check that plug has been inserted correctly into outlet and that
Power Switch, located on right side panel, is in ON (I) position.
•
Coffee Maker is in power-saving mode. Press any cup size button
to wake up Coffee Maker.
Espresso is not dispensing.
•
Pod inserted may be faulty. Try again with a new pod.
•
All lights are flashing: There is no water in Water Reservoir. Fill
with clean cold water.
•
Unit is preheating. Lights will slowly fade in and out during
preheating. Once preheating is finished, you can press desired
cup size button to begin brew cycle.
There is water at bottom of machine.
•
Make sure that Water Reservoir has been placed correctly into
position.
Pod cannot be placed into Pod Holder.
•
Check if Used Pod Container is full and needs to be emptied.
•
Handle may not have opened correctly. Try lifting Handle again.

Espresso Side

Pod cannot drop into Used Pod Container normally.
•
Used Pod Container is full and needs to be emptied.
•
Handle may not have opened correctly. Try lifting Handle again.
A slight hiss can be heard after espresso has been dispensed.
•
This is a function of Coffee Maker which is normal.
Espresso drips from espresso dispenser after brewing is
completed.
•
This is normal and dripping will stop. Keep cup on Cup Rest until
dripping stops.
Cup lights are flashing.
•
Water Reservoir is empty or Reservoir is not securely in place.
Add cold water to Water Reservoir. Place Water Reservoir
securely in Base.
•
Coffee Maker needs to be descaled. See Care and Cleaning on
page 8.
•
Espresso Lid is not closed. Close Lid.
9