Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting –
Coffee Maker will not brew/coffee not dispensing.
•
Piercing Needle may be clogged. Always remove Gray Removable
Needle Holder. Clean Piercing Needle in Lid of Coffee Maker as
shown on page 9.
•
Mineral deposits have formed. Clean Coffee Maker following
directions in Care and Cleaning section.
•
Too little water. Need 15 oz. (444 ml) or more.
Coffee tastes bad.
•
Too much water was added or too much or too little ground coffee
was added. Change ratio of water to coffee grounds or use less
water with coffee pods.
•
Poor coffee quality and freshness.
•
Poor water quality. Use filtered or bottled water.
Coffee sediment in cup.
•
Try a coarser grind of coffee, or add a #1 paper cone coffee filter
to Brown Removable Brew Basket. Make sure hinged Lid is closed
on Brown Removable Brew Basket.
Water on counter under unit.
•
Overfilled Water Reservoir. Do not add more than 40 oz.
(1.2 l) of water. Some mugs/cups do not pour cleanly and can
dribble water down side of cup and onto counter.
10
Single-Serve Side
Control Panel Notifications:
•
CLEAn: Coffee Maker needs to be cleaned. See page 9.
•
CLOSE LId: Coffee Maker Lid is not closed properly. Push Lid down
to lock into place.
•
OVEr LOAd: Needle is clogged or grounds basket is overloaded.
Do not fill grounds basket above MAX fill line. Always remove Gray
Removable Needle Holder and follow "Clogged Needle" instructions
on page 9.
•
FIL H2O: Not enough water. Add water to Water Reservoir and press
BREW NOW I/ button to clear Display. Press BREW NOW I/
button to restart brew cycle.
•
OVEr: Allow Coffee Maker to cool for 15 minutes. Make sure there is
water in Water Reservoir. Empty mug, and then press BREW NOW I/
button to restart brewing cycle.
Coffee overflows from Brew Basket.
•
Use Removable Brew Basket with Lid for ground coffee.
•
Use a lesser amount of ground coffee. 3 tablespoons (44 ml) is
maximum amount of grounds to brew.
•
When using whole bean coffee, a standard automatic drip coffee
grind will yield best results. Be careful not to overgrind, since very
finely ground coffee can cause overflow.
•
Black Seal around Needle in Removable Needle Holder is missing.
Carefully place seal around needle and push until in place.
Coffee overflows from travel mug or regular mug.
•
Empty mug after manually stopping brew cycle. Press BREW NOW
I/ button to start a new brewing cycle.
Coffee single-serve pod bursts.
•
There is variability in single-serve pod manufacturing process
which causes some types of single-serve pods to be weaker at
seams so foil seal fails. Try a different brand.
Delay Brew feature does not work with Single-Serve side.
•
Delay Brew feature is not designed to work with Single-Serve side.
Program mode is for Carafe side only.
Publicité
