Installation Instruction - bosal 011-398 Instructions De Montage

Masquer les pouces

Table des Matières

Les langues disponibles

44 14 07 07/13 / 05.00

Packing list: 1 Cable set

1 Socket

1 Socket retaining plate

Disconnect the earth lead from the battery.

Remove rear shelf, boot cover and container in boot. Remove covers inside boot near tail standing lights.

In order to connect electric bunch to connection socket drill a 6mm diameter hole on the right side of vehicle, in

spare wheel well. Expand existing hole to 20mm diameter. Secure the hole with anti-corrosion agent.

Connect the cable set in the following way:

a) Draw end of lead bunch with metal lead ends through the place referred to in point 3 from boot outside and

through a hole by connection socket handle, assemble supplied grommet in the drilled hole,

Draw attached rubber socket retaining plate over,

b) Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction agent),

c) Disassemble the socket and connect cables according to the following assignment:

7 pin

Function

Indicator left

Fog light

Earth

Indicator right

Tail light right

Stop light

Tail light left

Fog light

13 pin

Function

Indicator left

Trailer fog light

Rear fog light

Earth

Indicator right

Tail light right

Stop light

Tail light left

Reversing light

Trailer current supply

Charge line plus

Charge line earth

Not assigned

Earth (trailer)

Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied

nuts and screws:

a) Pay special attention to the right position of rubber retaining plate,

b) Put the cable set gently to avoid any folds and to secure it from possible wiping.

Electrical Set for Trailer Connection

7-pin

13-pin

3 Screws M5X35

3 Nuts M5

3 Spring washer