Install Patio Panel - Petsafe Freedom PPA11-13098 Manuel D'installation

Install Patio Panel

Step
2
2A
2B
NOTE:
sliding glass door track. Firmly pull down one side and then the other.
2C
6
Connection
Bar
Factory
Bottom
Installed
Door
Screws
Section
On Each
Side
You may need to pull down the height adjuster to fi t the Patio Panel in your
1-800-732-2677
NOTE:
2A
If you purchased a 96" Patio
Panel, fi rst assemble the bottom section
to the top section before proceeding with
the installation. Remove the four factory
installed screws from sides of connection
bars on bottom door section. Align and slide
connection bars on bottom section into top
section. Reinstall and tighten the four screws
through the four pre-drilled holes on sides of
top door section into the connection bars.
NOTE:
Remove all packaging materials,
including cardboard inserts inside the height
adjuster.
2B The Freedom
™
Patio Panel Pet Door inserts
into the opening in your sliding glass door
against the doorjamb. Your sliding glass door
will close against the Patio Panel.
With sliding glass door open, insert top of Patio
Panel with height adjuster into upper door track
on interior side of sliding glass door. Lift up and
position bottom of Patio Panel into lower door
track on interior side of the sliding glass door.
Ensure the side of the Patio Panel showing
fl ap screw heads is on the interior side of your
sliding glass door.
2C Move the Patio Panel against the
doorjamb.
The Patio Panel should fi t fl ush
against the doorjamb without any gaps. Make
sure the height adjuster is fully extended and
not tilted to one side. Ensure you are satisfi ed
with the fi t of the Patio Panel before drilling