Inserting A Blank Space During Recording - Sony HST-471 Mode D'emploi

4
Select the side from which to start
dubbing.
Press · to record from the front side.
Press ª to record from the reverse side.
5
Press PAUSE P to start dubbing.
To stop normal-speed dubbing
Press p on deck B.
To stop high-speed dubbing
Press p on both decks.
Tips
• During high-speed dubbing, only p is operative.
• If the original tape was recorded with Dolby NR
B, dubbing is automatically performed with Dolby
NR B. If, however, you want to monitor the sound
during normal-speed dubbing, set DOLBY NR to
B.
Note
If a TV set is placed near the system, noise may
occur during high-speed dubbing. In that case, turn
the TV set off or move it away from the system.
Dubbing only specific
portions
You can skip unwanted portions during
normal-speed dubbing.
1 Press p on deck A at the portion you want
to skip.
Deck B changes to recording pause.
2 Locate the point you want to resume
recording on deck A, then stop the tape.
3 Press PAUSE P to resume dubbing.
Inserting a blank
space during
recording
–– Record Muting
You can insert a blank space of 4 seconds
between each track or erase unwanted
portions on a tape.
POWER
0 )
p ª ·
§
1
Start recording.
2
Press REC MUTE R at the point you
want to insert a blank space.
"REC" flashes in the display and a blank
space is recorded on the tape.
After 4 seconds, P lights up and the tape
deck changes to recording pause.
3
Press PAUSE P or · to resume
recording.
While dubbing at normal speed, press
PAUSE P to resume recording.
Tip
To insert a blank space longer than 4 seconds, hold
down REC MUTE R as long as you want. After
4 seconds, "REC" flashes faster.
When you release REC MUTE R, P indicator lights
up and the tape deck changes to recording pause.
Press PAUSE P or · to resume recording.
P R r
0 )
p ª ·
§
2
3 3
EN
21