Publicité
Les langues disponibles
Les langues disponibles
4
ITEM(S) NEEDED
#6 x 2
g.
Secure the Aluminum Support Plate to the pontoon
support beam with two 1-1/2" bolts
(Item #6). Place one Flat Washer (Item #4) on each
bolt. Coat the threads of each bolt with
anti-seize.
h.
Put one bolt through each drilled hole so it passes
through the pontoon support beam and the
Aluminum Support Plate. Place a Flat Washer (Item
#4) and Nylock Nut (Item #7) at the end of each
bolt and secure each using a ½" wrench and ratchet
fitted with a ½" socket as shown.
5
ITEM(S) NEEDED
i.
Based on the distance between the two
Aluminum Support Plates, determine if space
between support beams will require the
installation of the Short Spanner Plate (Item #2)
or the Long Spanner Plate (Item #3). For proper
installation, the two slots on both sides of the
selected spanner plate should align with at least two
holes on each of the Aluminum Support Plates as
shown.
j.
Secure the spanner plate in place by placing two
screws in each slot and align it with the holes in
the Aluminum Support Plate. Place one Lock
Washer (Item #7) on each 1" screw (Item #8). The
screws will pass through the spanner plate and
Aluminum Support Plate and into the floor of the
pontoon. Use a drill with a #3 Phillips Bit to tighten
the screws in place. Make sure all hardware is
secure.
©2017 Johnson Outdoors Marine Electronics, Inc.
#4 x 4
#7 x 2
#2 x 1
Deck
Aluminum
Support
Plate
Flat Washer with
Nylock Nut
Deck
Aluminum
Support Plate
Support Beam
#3 x 1
5i
Proper Alignment
Aluminum
Spanner Plate
Support
Plate
Support Beam
Aluminum
5j
Aluminum
Support Plate
Support Plate
1-1/2" Bolt with
Flat Washer
#7 x 8
#8 x 8
Aluminum Support Plate
Spanner Plate
1" Screw with Lock Washer
minnkotamotors.com | 3
Publicité
