Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1
ITEM(S) NEEDED
a.
Complete installation of the Pontoon Edge Mount Kit
(1810225).
b.
Place the Aluminum Support Plate (Item #1) below
the pontoon deck against the closest and opposite
support beam that is parallel to the support plate
already installed with the Standard Talon Pontoon
Adapter Bracket mounting kit as shown.
NOTICE:
Be sure to verify adequate outboard
steering clearances, and that your installation will
not interfere with any previously installed cabling,
fuel lines, or wiring.
2
c.
Once placed, mark the Drilling Locations mid
length in each slot on the bottom of the pontoon
deck. Drill up through the floor using a 3/8" drill
bit on the marked locations.
d.
Mark Drilling Locations for the Aluminum Support
Plate on the face of the support beam, mid-length
in each slot for the mounting hardware. Drill
through the face of the beam using a 3/8" drill on
the marked location.
Drilling
Location
Aluminum
Support Plate
Drilling Location
2c
Drilling Location
©2017 Johnson Outdoors Marine Electronics, Inc.
#1 x 1
Deck
Support Beam
2d
Drilling Location
1b
Proper Alignment
Aluminum
Support Plate
Support Beam
3
ITEM(S) NEEDED
#5 x 2
e.
Secure the Aluminum Support Plate to the
pontoon deck with two 2" bolts (Item #5). Place
one Flat Washer (Item #4) on each bolt. Coat the
threads of each bolt with anti-seize. Place the
Aluminum Support Plate beneath the deck and
align the slots with the holes drilled through the
deck.
f.
With the washer in place, put one bolt in each of
the holes on top. Each bolt will pass through the
pontoon deck and the Aluminum Support Plate.
Place a Flat Washer (Item #4) and Nylock Nut
(Item #7) at the end of each bolt and secure each
using a ½" wrench and ratchet fitted with a ½"
socket.
2" Bolt with Flat Washer
Flat Washer with
Nylock Nut
Deck
Support Beam
#4 x 4
#7 x 2
Deck
Aluminum
Support
Plate
minnkotamotors.com | 2
Publicité
