JOCCA 6107 Manuel D'instructions page 8

8 | EN
-Press the button on the display or start exercising.
The display will start up in this way.
-In order to see the results obtained during the
exercise, please read the following procedure
carefully:
Automatic mode for seeing the results:
-Press the button just once. "SCAN" will flash.
You will see the results one by one (Pasos, Total
Pasos, Min, Calorías). The will be shown for
approximately 4 seconds.
Manual mode for seeing the results:
-To fix the function that you wish to see during
exercise, press the button one time after another
until fixing the function that you wish to see on the
screen (Pasos, Total Pasos, Min, Calorías).
-This apparatus has an automatic switch-off
function, which means that if the apparatus detects
no movement for 2 minutes then the display will
switch off automatically.
-Note: To put the display to "ZERO". Press the
button down for 3 seconds. All the counters will
go back to "0".
Battery change:
- Remove the display from its original position my
means of the 3 notches located around the meter,
and you will be able to access the
battery compartment without the need of any
tools.