Télécharger Imprimer la page

Important Safety Instructions - Bestway STEEL PRO Notice D'utilisation

Masquer les pouces Voir aussi pour STEEL PRO:

Publicité

Les langues disponibles

Les langues disponibles

WARNING

IMPORTANT SAFETY INSTRUCTIONS

Read and Follow All Safety Information
and Instructions.
Keep for future reference.
Failure to follow these warnings and
instructions can result in serious injury or
death to users, especially children.
WARNING
Prevent Drowning
Children under 5 are at highest risk for drowning.
Closely watch children who are in or near this pool.
WARNING
No Diving
You can break your neck and be
paralyzed!
WARNING
Stay away from drains & suction fittings
If drain or suction outlet cover is missing or broken, your hair, body,
and jewelry can get sucked into drain. You could be held under
water & drown! Do not use pool if drain or suction outlet cover is
missing or broken.
Prevent Young Children From Drowning:
Install fencing or approved barrier around all sides of pool.
State or local laws or codes may require fencing or other approved
barriers.
Check state or local laws and codes before setting up pool.
Drowning occurs silently and quickly. Assign an adult to supervise pool
and wear provided water watcher tag.
Keep children in your direct sight when they are in or near pool and
when you are filling and emptying pool.
When searching for a missing child, check pool first, even if you think
your child is in the house.
Pool presents a drowning hazard even during filling and draining of the
pool. Maintain constant supervision of children and do not remove any
safety barriers until the pool is completely empty and stowed away.
Refer to the list of barrier recommendations and guidelines as
described in CPSC Publication No.362.
Assign an adult to be responsible for watching children in the pool.
Give this person a "water watcher" tag and ask that they wear it the
entire time they are in charge of supervising children in the pool. If they
need to leave for any reason, ask this person to pass the "water
watcher" tag and the supervision responsibility to another adult.
Locate pumps and filters in such a way that children cannot climb on
them to gain access to pool.
If you have a ladder, refer to the ladder's manual for instructions.
If you have a pump, refer to the pump's manual for instructions.
WARNING
Electrocution Risk
Keep all electrical lines, radios,
speakers, and other electrical
devices away from pool. Do not
place pool near or under overhead
electrical lines.
Prevent Young Children From Gaining Access to Pool:
Remove pool ladders before leaving pool. Toddlers can climb ladder
and get into pool.
Position furniture away from pool so that children cannot climb and
gain access to pool.
When leaving pool, remove floats and toys from pool that might attract
a child.
Be Prepared to Respond to an Emergency:
Keep a working phone and list of emergency numbers near pool.
Become certified in cardiopulmonary resuscitation (CPR) so you can
respond to an emergency.
Electrocution Risk:
Keep all electrical lines, radios, speakers, and other electrical devices
away from pool.
Do not place pool near or under overhead electrical lines.
Suction Risk:
Replacement pump should never exceed the maximum flow rate
marked on the suction fitting.
For further safety tips check out the following websites:
www.homesafetycouncil.org
http://www.safety-council.org/info/child/water.html
www.safekids.org
www.nspi.org
Safety Barrier Guidelines for Residential Swimming Pool
Section I: Outdoor swimming pool
An outdoor swimming pool, including an inground, aboveground, or
onground pool, hot tub, or spa, should be provided with a barrier which
complies with the following:
1. The top of the barrier should be at least 48 inches above grade
measured on the side of the barrier which faces away from the
swimming pool. The maximum vertical clearance between grade
and the bottom of the barrier should be 4 inches measured on the
side of the barrier which faces away from the swimming pool.
Where the top of the pool structure is above grade, such as an
aboveground pool, the barrier may be at ground level, such as the
pool structure, or mounted on top of the pool structure. Where the
barrier is mounted on top of the pool structure, the maximum
vertical clearance between the top of the pool structure and the
bottom of the barrier should be 4 inches.
2. Openings in the barrier should not allow passage of a 4-inch
diameter sphere.
3. Solid barriers, which do not have openings, such as a masonry or
stone wall, should not contain indentations or protrusions except
for normal construction tolerances and tooled masonry joints.
4. Where the barrier is composed of horizontal and vertical members
and the distance between the tops of the horizontal members is
less than 45 inches, the horizontal members should be located on
the swimming pool side of the fence. Spacing between vertical
members should not exceed 1-3/4 inches in width. Where there are
decorative cutouts, spacing within the cutouts should not exceed
1-3/4 inches in width.
5. Where the barrier is composed of horizontal and vertical members
and the distance between the tops of the horizontal members is 45
inches or more, spacing between vertical members should not
exceed 4 inches. Where there are decorative cutouts, spacing
within the cutouts should not exceed 1-3/4 inches in width.
6. Maximum mesh size for chain link fences should not exceed 1-3/4
inch square unless the fence is provided with slats fastened at the
top or the bottom which reduce the openings to no more than 1-3/4
inches.
7. Where the barrier is composed of diagonal members, such as a
lattice fence, the maximum opening formed by the diagonal
members should be no more than 1-3/4 inches.
8. Access gates to the pool should comply with Section I, Paragraphs
1 through 7,and should be equipped to accommodate a locking
device. Pedestrian access gates should open outward, away from
the pool, and should be self-closing and have a self-latching
device. Gates other than pedestrian access gates should have a
self-latching device. Where the release mechanism of the
self-latching device is located less than 54 inches from the bottom
of the gate, (a) the release mechanism should be located on the
4

Publicité

loading