Important - Bestway STEEL PRO Notice D'utilisation

Masquer les pouces Voir aussi pour STEEL PRO:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

13 ft. 1 in. x 6 ft. 11 in. x 32 in. (4.00 m x 2.11 m x 81 cm)
B
A
A
C
D
F
M
CHOOSE THE CORRECT LOCATION

IMPORTANT:

The pool must be set up on a completely
flat and level surface. Please do not install the pool if the surface is
Inclined or sloped.
Correct conditions to set up the pool:
• The selected location has to be capable of uniformly supporting the
weight for the entire time the pool is installed, moreover the location
must be flat and must be cleared of all objects and debris including
stones and twigs.
• We recommend positioning the pool away from any objects kids
could use to climb into the pool.
NOTE:
Position the pool near an adequate drainage system to
deal with overflow or to discharge the pool.
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal
injury and/or damage to personal property and will void the warranty
and prevent any service claims.
• Sand should not be used to create a level base; the ground must be
dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location
does not contain underground utility pipes, lines or cables of any
kind.
• Do not set up the pool on driveways, decks, platforms, gravel or
asphalt surfaces. The selected location should be firm enough to
withstand the pressure of the water; mud, sand, soft / loose soil or tar
are not suitable.
• Grass or other vegetation under the pool will die and may cause
odors and slime to develop, therefore we recommend removing all
grass from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may
grow through the ground cloth or liner.
NOTE:
Check with your local city council for by-laws relating
to fencing, barriers, lighting and safety requirements and ensure you
comply with all laws.
NOTE:
If have a filter pump, refer to the pump's manual for
instructions.
NOTE:
The ladder must match the pool size and should to be
used only for entering and exiting the pool. It is forbidden to exceed
the permitted payload of the ladder. Check regularly if the ladder is
properly assembled.
Installation
Assembly of the Frame pool can be completed without tools.
NOTE:
It is important to assemble pool in the order shown
below. Install your pools according to the above illustrations.
ATTENTION:
Do not drag the pool on the ground in
order to avoid damaging the linear on sharp objects. Bestway
Inflatables will not be responsible for damage caused to the pool due
to mishandling or failure to follow these instructions.
1
C
A
D
A
B
I
A
A
G
H
N
2
3
J
K
4
5
6
7
8
7
8 ft. 6 in. x 67 in. x 24 in.
(2.59 m x 1.70 m x 61 cm)
8 ft. 6 in. x 67 in. x 24 in.
(2.59 m x 1.70 m x 61 cm)

Publicité

Table des Matières
loading

Table des Matières