Bestway STEEL PRO Notice D'utilisation page 8

FILLING POOL WITH WATER
ATTENTION:
Do not leave pool unattended while filling
with water
1. Fill pool to drain valve.
STOP
2. Turn water off. Check that the water is not collecting on any side to
ensure the pool is level. If pool is not level, drain water and re-level
ground by digging out. Never attempt to move the pool with water in
it, serious personal injury or damage to the pool may result.
NOTE:
Your pool may contain a great deal of pressure. If
your pool has any bulge or uneven
side then the pool is not level, the
sides may burst and the water may
discharge suddenly causing serious
personal injury and/or damage to
property.
3. If level, fill pool to lowest pump valve.
STOP
4. Turn water off. Check valves for secure fit.
5. Fill pool until water capacity is 90%, DO NOT OVERFILL as this
could cause the pool to collapse. In times of heavy rainfall you may
need to empty some of the water to ensure the level is correct.
6. Check pool for any leaks at valves or seams, check ground cloth for
any evident water loss. Do not add chemicals until this has been
done.
7. In the event of a leak, patch your pool using the underwater
adhesive repair patch provided. Refer to the FAQ's for further
information.
Proper Water Level
NOTE:
Drawings for illustration purpose only. May not reflect
actual product. Not to scale.
ATTENTION:
Do not use pump when pool is in use.
During the season of use of the swimming pool, the filtration system
must be necessarily put into service every day, enough for a long time
to assure at least a complete renewal of the volume of water.
Pool Maintenance
If you do not adhere to the maintenance guidelines below, your health
might be at risk, especially that of your children.
IMPORTANT:
water chemicals the PVC can be damaged and become discolor.
The following table lists the sequence of the tests that should be
carried out for the ideal values and possible actions. Regularly check
the pH value and chlorine concentration weekly and adjust to the ideal
values.
TEST
pH value
Cyanuric acid
Free chlorine
Chlorine compound
Algae
Calcium hardness
0°
If you don't respect the ideal values of the
IDEAL VALUES
7.4– 7.6
30 – 50 ppm
2 – 4 ppm
0
None visible
200 – 400 ppm
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of
chemicals and pH kits. One of the most important factors to increase
the life of the liner is to keep continuously clean and healthy water.
Please strictly follow the instructions from professional technicians
for the water treatment through the use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet before
entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean cloth.
7. Please be careful in case of rain water, kindly check that the water
level is not higher than the expected. If so, YOU HAVE TO
DISCHARGE THE EXCESS WATER.
Proper maintenance can maximize the life of your pool.
During the season of use of the swimming pool, the filtration system
must be necessarily put into service every day, enough time to assure
at least a complete renewal of the volume of water.
Repair
Check pool for any leaks from valves or seams, check the ground cloth
for any evident water loss. Do not add chemicals until this has been
done.
NOTE:
In the event of a leak, patch your pool using the
underwater adhesive repair patch provided. Refer to the FAQs for
further information.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter
clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in
the area where you are going to drain your pool. (Check local
regulations for drainage by-laws).
3. Screw control ring of the hose adaptor onto the drain valve
clockwise. The drain valve will be open and water will start to drain
ATTENTION:
automatically.
controlled with the control ring.
4. When draining is finished, unscrew the control ring to close the
valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and
store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent
pool from sticking together, fold pool carefully. If pool is not
completely dry, mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate
temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as
per above instructions also.
5. Improper draining of the pool might cause serious personal injury
and/or damage to personal property.
6. We strongly recommend the pool is disassembled during the off
season (winter months). Store in a dry location out of children's
reach.
NOTE:
If your purchased pool set do not have any circulation
system, you can purchase separately. But please make sure the
equipment can turn over total volume of pool water no less than once
every 12 hr. You can check the water capacity on packaging to select
suitable circulation system. Pump provided for the circulation of water
shall be tested by a Nationally Recognized Testing Laboratory and
certified to conform to UL1081.
Also make sure the selected suction outlet sold with the pump should
be tested by a Nationally Recognized Testing Laboratory and certified
to conform to ASME/ANSI A112.19.8 or its successor standard
ANSI/APSP-16, in order to prevent suction entrapment.
8
Water flow can be
Do not leave the drained pool outside.