Toshiba RBC-TRP100E Manuel D'installation page 29

Branch Kit 1:3
To recognize the position of the
corresponding indoor unit though
the indoor unit No. is known
Check the position during operation stop.
(Be sure to stop operation of the unit.)
1,3
1
Procedure
Push simultaneously
for 4 seconds or more.
After a while, the display part flashes and
the display appears as shown below.
At this time, the position can be checked
because fan and louver of the indoor unit
operate.
• For the group control, the indoor unit No.
is displayed as [
louvers of all the indoor units in the
group control operate.
Check the displayed CODE No. is [01].
• When the CODE No. is other than [01],
push button to erase the display and
repeat procedure from the first step.
(After pushing
the remote controller is not accepted for
approx. 1 minute.)
(* Display changes according to
the model No. of indoor unit.)
1
2
+ buttons
] and fans and
button, operation of
2
Procedure
In the group control, every pushing
button, the indoor unit No. in the group
control is displayed in order.
At this time, the position of the indoor unit
can be confirmed because only fan and
louver of the selected indoor unit operate.
(For a group control, No. of the firstly
displayed indoor unit becomes the header
unit.)
3
Procedure
After confirmation, push
the mode to the usual mode.
When pushing
disappears and the status becomes the
usual stop status. (When pushing
the operation from the remote controller is
not accepted for approx. 1 minute.)
28
button to return
button, the display
button
EN
EN